High pressure air-assisted, 4000 psi (28 mpa, 280 bar) maximum working fluid pressure, 100 psi (0.7 mpa, 7 bar) maximum working air pressure (28 pages)
Page 1
Instructions - Parts 24N318 Round Spray Kit 3A2498A To convert a Pro Xp™ Electrostatic Air Spray Gun to a round spray pattern. For professional use only. Important Safety Instructions Read all warnings and instructions in this manual and in your Pro Xp Electrostatic Air Spray Gun manual.
Installation 5. Make sure the electrode needle is finger-tight. 6. Trigger the gun while installing the fluid nozzle (4) with the multi-tool provided with the gun. Tighten until the fluid nozzle seats in the gun barrel (1/8 to 1/4 turn past hand-tight). To reduce the risk of injury, follow the Pressure Relief Procedure in your Pro Xp manual before 7.
Page 3
Installation 8. Place a wrench on the flats of the air adjustment 11. Screw the new atomizing air restrictor valve (29) valve housing and unscrew the valve from the into the gun, using a wrench on the flats of the gun.
Page 4
Parts Parts Ref. Part No. Description NOTE: Items marked with a ★ are shown for reference and are not included in the kit. 24N729 NOZZLE, round spray 24N645 O-RING, conductive 111507 O-RING; fluoroelastomer 24N731 AIR CAP, round spray 24N733 ATOMIZING AIR RESTRICTOR VALVE, round spray 24N732 FAN AIR ADJUSTMENT...
Performance Chart Performance Chart Air Flow Adjustment In most applications using the round spray kit, it is desirable to use a very low air flow through the air Heavy viscosity; 30 sec, cap while maintaining enough pressure at the gun #3 Zahn inlet for full electrostatic power (about 40 psi [0.3 MPa, 2.8 bar]).
Graco to be defective. This warranty applies only when the equipment is installed, operated and maintained in accordance with Graco’s written recommendations. This warranty does not cover, and Graco shall not be liable for general wear and tear, or any malfunction, damage or wear caused by faulty installation, misapplication, abrasion, corrosion, inadequate or improper maintenance, negligence, accident, tampering, or substitution of non-Graco component parts.