Installing And Removing A 2½ Inch Drive (Screw Fastened) - Fujitsu ESPRIMO D7 Series Operating Manual

It may be necessary to modify the entry for the drive in the BIOS Setup.
Installing and removing a 2½ inch drive (screw fastened)
Installing a drive
► Remove the casing cover (see chapter
► Fold out the drive cage (see chapter
► Slide the drive into the bay (1).
► Secure the drive with the screws (2).
► Connect the cables at the drive and at the mainboard. Make sure the polarity is correct.
► Fold the drive cage into the closed position again (see chapter
► Fit the casing cover onto the casing again (see chapter
If necessary, you must adjust the entry for the drive accordingly in the BIOS Setup.
Fujitsu
"Removing the casing cover", Page
"Opening the drive cage", Page
1
"Reattaching the casing cover.", Page
System expansions
34).
45).
2
"Closing the drive cage", Page 46).
35).
53