Troubleshooting - DeLonghi ECAM23X.13 Instructions For Use Manual

Bean to cup espresso and cappuccino machine
Table of Contents

Advertisement

LIGHTS DISPLAYED
FLASHING
FLASHING
FLASHING
FLASHING

21. TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
The coffee is not hot.
POSSIBLE CAUSE
The pre-ground coffee function has been
selected without placing any pre-ground
coffee in the funnel (A4)
ON
The pre-ground coffee funnel (A4) is
clogged
The machine must be descaled
Too much coffee has been used
The water circuit is empty
The inside of the machine is very dirty
ON
The infuser (A9) has not been replaced
after cleaning
POSSIBLE CAUSE
The cups were not preheated.
The internal circuits of the appliance have
cooled down because 2/3 minutes have
elapsed since the last coffee was made.
A low coffee temperature is set.
REMEDY
Place pre-ground coffee in the funnel (fig. 17) or
deselect the "pre-ground" function.
Empty the funnel with the help of a brush as de-
scribed in section "16.8 Cleaning the pre-ground
coffee funnel".
The descaling procedure described in section
"17. Descaling" needs to be performed.
Select a milder taste by turning the dial (B6)
anticlockwise.
Turn the steam/hot water dial (A21) to the I posi-
tion until delivery stops, then bring it back to the
0 position. If the alarm occurs while hot water
or steam is being delivered, turn the dial to the
0 position. Turn the steam/hot water dial to the I
position until delivery stops, then bring it back to
the 0 position. If the problem persists, make sure
the water tank (A7) is fully inserted.
Clean the inside of the appliance thoroughly, as
described in section "16. Cleaning". If the mes-
sage is still displayed after cleaning, contact a
customer service centre.
Insert the infuser as described in section "16.9
Cleaning the infuser".
REMEDY
Warm the cups by rinsing them with hot
water (Please note: you can use the hot
water function).
Before making coffee, rinse the internal
circuits by pressing the
Set a higher coffee temperature in
the menu (see section "9. Setting the
temperature").
17
button (B5).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecam25x.23Ecam25x.31Ecam25x.33Ecam25x.41

Table of Contents