Power On/Off; 6-4.1. Power On; 6-4.2. Stand-By Power Mode Button; 6-4.3. Power Off - Clover LCD2084 Instruction Manual

Instruction Manual
Stand-alone DVR

6-4. Power On/Off

6-4.1. POWER ON

On the rear panel:
Turn on the POWER switch on the rear panel (See
when the POWER switch is ON.
By Stand-by Power Mode Button
Press this button on the front panel (See
(MAIN) switch is turned ON and the Stand-by Power Mode Button is turned OFF.

6-4.2. STAND-BY POWER MODE BUTTON

In order to extend the lifetime of the LCD screen and the backlights inside the monitor, press
the POWER button located on the front panel (See [Fig. 5-1]) to turn OFF if you don't need
to observe the system for a long time. The system will continue recording when it is in the
recording mode even though the Stand-by Power Mode Button is turned OFF.

6-4.3. POWER OFF

By pressing the Stand-by Power Mode Button:
Press the POWER button on the front panel for 3 seconds and then the POWER OFF
message as shown in [Fig. 6-2] will be displayed on the screen.
▫ Click the OK button to turn the power OFF.
On the remote controller:
Press the POWER button on the remote controller and then the following message will be
displayed on the screen.
Fig.5-2
) to turn ON the system when the POWER
Fig.5-1
[Fig. 6-2 Message of POWER off]
34
). The LED on the front panel is lit