Replacing The Fuses - Yamaha NIKEN GT 2020 Owner's Manual

Periodic maintenance and adjustment
battery tends to discharge more quick-
ly if the vehicle is equipped with op-
tional electrical accessories.
NOTICE
To charge a VRLA (Valve Regulated
Lead Acid) battery, a special (con-
stant-voltage) battery charger is re-
quired. Using a conventional battery
charger will damage the battery.
To store the battery
6
1. If the vehicle will not be used for
more than one month, remove the
battery, fully charge it, and then
place it in a cool, dry place.
NOTICE: When removing the
battery, be sure to turn the main
switch off, then disconnect the
negative lead before discon-
necting the positive lead.
2. If the battery will be stored for
more than two months, check it at
least once a month and fully char-
ge it if necessary.
3. Fully charge the battery before
installation. NOTICE: When in-
stalling the battery, be sure to
turn the main switch off, then
connect the positive lead before
connecting the negative lead.
[ECA16842]
ECA16522 4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
NOTICE
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
[ECA16304]

Replacing the fuses

The fuse boxes and individual fuses
are located under the rider seat (see
page 3-27) and behind panel A (see
page 6-9).
To access fuse box 1, the main fuse,
ECA16531
and the ABS motor fuse, remove the
rider seat. (See page 3-27.)
1. ABS motor spare fuse
2. ABS motor fuse
3. Fuse box 1
4. Main fuse
6-31
2
1
3
EAU84650
4