Yamaha NIKEN GT 2020 Owner's Manual page 24

Instrument and control functions
3
1
1. Cruise control setting switch "RES+/SET–"
2. Cruise control setting indicator light "SET"
Adjusting the set cruising speed
While the cruise control system is op-
erating, push the "RES+" side of the
cruise control setting switch to in-
crease the set cruising speed or the
"SET–" side to decrease the set speed.
TIP
Pushing the setting switch once will
change the speed in increments of ap-
proximately 2.0 km/h (1.2 mi/h). Hold-
ing the "RES+" or "SET–" side of the
cruise control setting switch down will
increase or decrease the speed contin-
uously until the switch is released.
You can also manually increase your
2
traveling speed using the throttle. After
you have accelerated, you can set a
new cruising speed by pushing the
"SET–" side of the setting switch. If you
do not set a new cruising speed, when
you return the throttle grip, the vehicle
will decelerate to the previously set
cruising speed.
Deactivating the cruise control sys-
tem
Perform one of the following opera-
tions to cancel the set cruising speed.
The "SET" indicator light will go off.
 Turn the throttle grip past the
closed position in the deceleration
direction.
1. Deceleration direction
 Apply the front or rear brake.
 Squeeze the clutch lever.
 Use the shift pedal.
Push the power switch to turn off the
cruise control system. The "
tor light and the "SET" indicator light
will go off.
TIP
Traveling speed decreases as soon as
the cruise control system is deactivat-
ed; unless the throttle grip is turned.
Using the resume function
Push the "RES+" side of the cruise
control setting switch to reactivate the
cruise control system. The traveling
speed will return to the previously set
cruising speed. The "SET" indicator
light will come on.
It is dangerous to use the resume
1
function when the previously set
cruising speed is too high for current
conditions.
3-9
" indica-
WARNING
EWA16351