Yamaha NIKEN GT 2020 Owner's Manual page 38

Instrument and control functions
TCS "2": Maximizes traction control
assist; wheel spin is most strongly con-
trolled.
TIP
 When the vehicle is turned on,
3
traction control is turned on and
set to "1" or "2" (whichever was
last selected).
 Turn the traction control system
off to help free the rear wheel if the
vehicle gets stuck in mud, sand, or
other soft surfaces.
NOTICE
Use only the specified tires. (See
page 6-16.) Using different sized
tires will prevent the traction control
system from controlling tire rotation
accurately.
Setting the traction control system
WARNING
Be sure to stop the vehicle before
making any setting changes to the
traction control system. Changing
settings while riding can distract the
operator and increase the risk of an
accident.
TCS settings can be changed only
when the vehicle is stopped and the
throttle closed.
 Push the "TCS" button to change
between TCS settings "1" and "2".
 Push the button for two seconds
to turn the traction control system
off.
 Push the button again to turn trac-
tion control back on (TCS will re-
ECA16801
turn to the previous setting).
Resetting the traction control sys-
tem
The traction control system will auto-
matically disable when:
 a wheel comes off the ground
while riding.
 excessive rear wheel spin is de-
EWA15441
tected while riding.
 a wheel is rotated by external for-
ces with the vehicle power on
(such as when performing mainte-
nance).
If the traction control system is dis-
abled, both the "
the "
1. Engine trouble warning light "
2. TCS display
3. Traction control system indicator light "
Should this occur, try resetting the sys-
tem as follows.
1. Stop the vehicle and turn the vehi-
2. Wait a few seconds and then turn
3. The "
3-23
" indicator light and
" warning light will come on.
1 2
"
cle off.
the vehicle back on.
" indicator light should
turn off and the system be en-
abled.
3
"