Eizo RadiForce GX530-BL Manual page 8

No picture
If a problem still remains after applying the suggested remedies, contact your local dealer.
Problem
1. No picture
• Power indicator does not light.
• Power indicator is lighting orange or green.
• Power indicator flashes orange and green.
2. The message below appears.
• This message appears when no signal is
input.
Example:
• The message shows that the input signal is
out of the specified frequency range.
Example:
fD: Dot Clock
fH: Horizontal Scan Frequency
fV: Vertical scan frequency
6
Possible cause and remedy
• Check whether the power cord is connected properly.
• Turn the main power switch on.
• Press .
• Turn off the main power, and then turn it on again a few
minutes later.
• Switch the input signal. For details, refer to the User's
Manual (on the CD-ROM).
• Operate the mouse or keyboard.
• Check whether the PC is turned on.
• When the Presence Sensor is set at a value from "Level-1"
to "Level-4", the monitor may have shifted to the power
saving mode. Come near to the monitor.
• There is a problem in the device that uses DisplayPort
connection. Solve the problem, turn off the monitor, and
then turn it on again. Refer to the user's manual of the
device that uses DisplayPort connection for details.
This message appears when the signal is not input correctly
even when the monitor functions properly.
• The message shown left may appear, because some PCs
do not output the signal soon after power-on.
• Check whether the PC is turned on.
• Check whether the signal cable is connected properly.
• Switch the input signal. For details, refer to the User's
Manual (on the CD-ROM).
• Check whether the PC is configured to meet the resolution
and vertical scan frequency requirements of the monitor
(see "Compatible Resolutions").
• Reboot the PC.
• Select an appropriate display mode using the graphics
board's utility. Refer to the manual of the graphics board
for details.