Schumacher SPI PRO 16A Manual page 4

- Connect the red eyelet output wire to the positive (+) terminal of the battery.
- Ensure that the two eyelets are properly secured to the battery terminals by
ensuring optimal electrical contact.
- Secure the connector end and cable run with cable ties at a point in the vehicle
away from the fuel line (do not use metal clamps or other material that could
damage the output cable).
Charging batteries not connected to a vehicle
1.Before starting ensure that the power cord is disconnected from the mains
socket.
2. Connect the output conductor with red clamps to the positive (+) pole of the
battery.
3. Connect the output conductor with black clamps to the negative (-) pole of the
battery.
4. Caution: ensure that both clamps have adequate contact with the battery
terminals.
HOW TO USE THE BATTERY CHARGER
1. Once the output clamps have been connected to the battery, connect the
power cord to the mains socket, making sure that the voltage corresponds to the
rated voltage of the charger.
2. With the charger in "stand-by" mode, set the appropriate charge parameters
using the mode button to select the correct voltage.
For 12V batteries the following charging parameters can be selected via the
"Function» button:
4A STD
8A STD
16A STD
4A AGM
8A AGM
16A AGM
• For charging 12V 5Ah to 80Ah batteries
• Maintenance for 12V 5Ah to 120Ah batteries
• Suitable for charging WET and Gel batteries
• For charging 12V 50Ah to 160Ah batteries
• Maintenance for 12V 50Ah to 250Ah batteries
• Suitable for charging WET and Gel batteries
• For charging 12V 90Ah to 360Ah batteries
• Maintenance for 12V 90Ah to 550Ah batteries
• Suitable for charging WET and Gel batteries
• For charging 12V 5Ah to 80Ah batteries
• Maintenance for 12V 5Ah to 120Ah batteries
• Suitable for charging AGM-START & STOP and AGM-SPIRAL and EFB or WET
batteries with temperatures below 5C°
• For charging 12V 50Ah to 160Ah batteries
• Maintenance for 12V 50Ah to 250Ah batteries
• Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB or WET
batteries with temperatures below 5C°
• For charging 12V 90Ah to 360Ah batteries
• Maintenance for 12V 90Ah to 550Ah batteries
• Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB or WET
batteries with temperatures below 5C°
EN