Appendix A: Icons - Trane FARRAR ULC Series Installation, Operation And Maintenance Manual

APPENDIX A: ICONS

The following is a list of the icon symbols used throughout this manual.
Icon Description*
Home Screen*
Previous Screen*
Next Screen*
System Setup*
System Health
System Information
Technical Service
Acknowledgment
Cancel Action
Alarm Silence
Warning
Alarm
Service
Additional Information, if applicable
Takes you back to Home Screen.
Takes you back to the prior screen.
Advances you to the next screen.
Displays the system setup screens for alarms, alarm delays, defrost cycles, screen
settings, service intervals and factory defaults in sequential order.
Displays the general system health screens for primary cooling, defrost status, and
system critical temperatures in sequential order.
Displays the general information concerning the system, such as typical serial label
information, software revisions, and support contact information.
Allows access to the technical and service functions of the unit. These functions will
typically be under log-in security protection and should only be accessed by qualified
service personnel.
Accepts the action.
This cancels the action.
Displays during an active alarm. Touching this icon will silence the audible alarm for a
period of time set up by the user. Should the alarm condition remain active, the audible
will sound again at the end of the delay period.
Displays during an active warning and is visible when a warning message is active.
Touching this button displays the active warning message(s). A warning informs users
that an Alarm Condition may occur if the warning conditions are not resolved within the
programmed delay period. Warning example: System in defrost mode.
Displays during an active alarm and is visible when an alarm condition is active. Touching
this button will display the active alarm condition(s). Action is required by the end user
to resolve the alarm condition. Alarm examples: Door open, system failure.
Displays to indicate the system is due for maintenance or calibration.
ULC SERIES INSTRUCTION MANUAL
48