Toro Reelmaster 5010-H Diagnostic Manual page 282
Hide thumbs
Also See for Reelmaster 5010-H:
- Service manual (335 pages) ,
- Operator's manual (128 pages) ,
- Installation instructions manual (12 pages)
Table of Contents
Advertisement
Location
Harness
1
Main
2
Main
1
Main
2
Main
Pass
The resistance tests passed, but the voltage readings in Step 4 are still bad.
Note:
Do not go to Step 6 until after the voltage readings in Step 4 are good.
Fail
One or more of the power and ground wiring tests failed. Repair or replace the worn or damaged
parts. Go to
Returning the Machine to Service (page 22)
Step 6: Swap cutting reel motors between cutting units.
All of the cutting reel motors are identical.
1.
Go to
Preparing for Troubleshooting and/or Testing (page 22)
2.
Unplug the 48 Vdc battery disconnect to prevent unexpected cutting unit operation. Refer to
and Disconnecting the 48 Vdc Battery System (page
3.
Swap cutting reel motor 1 with a cutting reel motor from a different cutting unit. You can obtain more
information on replacing the cutting reel motor in Chapter 5 of the 5010-H Service Manual.
4.
Plug in the 48 Vdc battery disconnect. Refer to
(page
19).
5.
Operate the machine.
The fault moves to the
new position.
The fault stopped
repeating.
Step 7: Use Toro DIAG to program the replacement cutting reel motor.
1.
Remove the access panel from the outer cover of the control arm.
2.
Connect a PC with Toro DIAG software to the machine via a Toro DIAG Cable (Part No. 115-1944). Refer
to
Toro DIAG - Quick Start (page
Pin
Connector
P47
2
Ground)
P37
4
Ground)
P46
1
P47
2
Ground)
If the fault follows the cutting reel motor to the new cutting unit, replace the
cutting reel motor. Go to Step 7.
If the fault no longer repeats, note the position change of the cutting reel motor
in the maintenance records for the machine. Should the fault repeat in the
future, troubleshooting may be resumed where you left off. Go to
Machine to Service (page 22)
24).
Wire
Expected
Color
Reading
Black
(48V
Less than
2 ohms
Black
(48V
White
24k to 26k
ohms
Black
(48V
and follow the steps listed.
and follow the steps listed.
19).
Connecting and Disconnecting the 48 Vdc Battery System
and follow the steps listed.
282
Connector Graphic
Connecting
Returning the
Advertisement
Table of Contents
Troubleshooting
