Connext Setup - Other Bluetooth Devices - Garmin GTN 725 Cockpit Reference Manual

Connext Setup - Other Bluetooth Devices

NOTE: This feature is available in software v6.00 or later.
The GTN can also configure the Bluetooth transceiver in other units, such as
the GMA 35c and GTX 345.
Touch to set
Bluetooth
name.
From the Connext Setup page, the pilot can enable/disable Bluetooth, change
the Bluetooth name, and manage paired devices. On the Paired Devices page,
the device status indicates if the portable device is paired and connected. To
connect a different device when the maximum number are already connected,
the existing connection must be ended by removing the portable device pairing
or by disconnecting or disabling Bluetooth on the portable device. Removing a
device from this page by pressing "Remove" will require the device to be paired
again before reconnecting.
NOTE: Only one portable device can be connected to the GMA 35c at a
time.
NOTE: If the pairing is removed from either device (portable device or
installed avionics) it must be removed on the other device before a new
pairing to that same device is established again. Essentially, pairing must
be removed on both devices before re-pairing.
New devices can only be paired while the unit is in "Pairing Mode." Pairing
mode is active while on the Connext Setup page or the Manage Paired Devices
page. The pairing must be initiated by the portable device. A pop-up will be
displayed on the portable device to confirm the pairing.
190-01007-04 Rev. L
Connext Setup for GMA 35c
GTN 725/750 Cockpit Reference Guide
Touch to enable
Bluetooth.
Touch to manage
paired devices.
59