Voice Command Instructions; Qualification Procedure - Garmin GTN 725 Cockpit Reference Manual

Voice Command Instructions

1. Press and hold the PTC switch.
2. Speak the entire command into the headset MIC.
3. Release the PTC switch.
• A positive tone (low-to-high) indicates the command has been recognized
and executed. (i.e., page changed, radio tuned, MIC selected, etc.)
• A negative tone (high-to-low) indicates the command is either
unrecognizable or invalid.
Successful Command Example
"Show approaches page" is spoken, the approach selection page displays
immediately, and a positive tone sounds.
Unsuccessful Command Example
"Show map page" is spoken and the traffic page displays.
"Show map page" is spoken and a negative tone sounds.
Qualification Procedure
Speak the unbold phrase if the voice command in this procedure is not
applicable to the aircraft' s configuration. If the total number of successful
commands is less than 17, the voice commands must be disabled. For instructions
on how to activate and deactivate voice commands, refer to the GTN 725/750
Pilot' s Guide, P/N 190-01007-03.
Example: If the requirement states a COM radio is required, but your GTN
does not a have a COM radio, use the unbold command.
1. Start the GTN and acquire a GPS position.
2. Conduct the voice commands in sequential order while wearing an
aviation headset. If necessary, a command can be attempted twice.
3. When the command is successful check the box next to the command.
98
GTN 725/750 Cockpit Reference Guide 190-01007-04 Rev. L