Table of Contents
Advertisement
Leveling the Mower Deck (continued)
Leveling the Mower Deck
1. Set the anti-scalp rollers to the top holes or remove them completely for this procedure.
2. Set the height-of-cut lever to the 76 mm (3 inch) position.
3. Place 2 blocks
6.6 cm (2-5/8 inches), under each side of the
front edge of the deck.
Do not place the blocks under the anti-scalp roller brackets.
4. Place 2 blocks
the rear edge of the deck.
5. Loosen the fasteners connecting the chains on
all 4 corners of the deck and ensure that the
mower deck sits securely on all 4 blocks.
6. Remove any slack from the deck chains and
ensure that the deck-lift foot lever is pushed
back against the stop.
7. Tighten the fasteners.
8. Ensure that the blocks fit snugly under the
deck edge and that all attachment bolts are
tight.
9. Check the side-to-side level and front-to-rear
level; repeat the procedure until the
measurements are correct.
3464-628A
, each having a thickness of
IMPORTANT
, each having a thickness of 7.3 cm (2-7/8 inches), under each side of
Page 5–28
G454742
G451475
Maintenance: Mower-Deck Maintenance
Advertisement
Table of Contents
