Table of Contents
Advertisement
Blade Service (continued)
Removing the Blades
1. Hold the blade end using a rag or thickly padded glove.
2. Remove the blade as shown.
Sharpening the Blades
1. Use a file to sharpen the cutting edge at both
ends of the blade. Ensure to maintain the
original angle
Note:
from both cutting edges so that the blade
retains its balance.
2. Check the balance of the blade
on a blade balancer
Note:
position, the blade is balanced and can be
used.
If the blade is not balanced, file some metal off the end of the sail area only.
3. Repeat this procedure until the blade is balanced.
Maintenance: Mower-Deck Maintenance
.
Remove the same amount of material
.
If the blade stays in a horizontal
G451425
G000552s
by putting it
G000553s
Page 5–25
3464-628 A
Advertisement
Table of Contents
