Lenovo ThinkSystem SR950 V3 Manual page 190

4. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFSM0002N: Boot Permission denied by Management Module: System Halted.
Severity: Warning
User Action:
Complete the following steps:
1. AC cycle the system.
2. Check XCC logs,and make sure the PSU installation follows support guide line.
3. Review power policies and system configuration settings in the XCC GUI.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFSM0003N: Timed Out waiting on boot permission from Management Module: System
Halted.
Severity: Warning
User Action:
Complete the following steps:
1. AC cycle the system.
2. Check XCC logs,and make sure the PSU installation follows support guide line.
3. Review power policies and system configuration settings in the XCC GUI.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFSM0004M: An XCC communication failure has occurred.
Severity: Warning
User Action:
Complete the following steps:
1. AC cycle the system.
2. Make sure XCC and UEFI FW are operating with same compatible level.
3. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to this
error.
4. Reflash XCC Firmware.
5. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFSM0007I: The XCC System Event log (SEL) is full.
Severity: Info
User Action:
Complete the following steps:
1. Use BMC Web Interface to clear event logs.
2. If BMC communication is unavailable, use F1 Setup to access System Event Logs Menu and Choose
Clear BMC System Event Logs and Restart Server.
186
ThinkSystem SR950 V3 Messages and Codes Reference