Lenovo ThinkSystem SR950 V3 Manual page 185

Complete the following steps:
1. Check Lenovo Support site for an applicable service bulletin or UEFI firmware update that applies to
this error.
2. Reboot the system.
3. If the problem persists, collect Service Data logs.
4. Contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU0034L: The TPM could not be initialized properly.
Severity: Error
User Action:
Complete the following steps:
1. Reboot the system. Reflash UEFI image.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU0035N: A 3-strike timeout has occurred on processor [arg1].
Severity: Fatal
Parameters:
[arg1]: Socket number, 1-based.
User Action:
Complete the following steps:
1. Check Lenovo Support site for an applicable service bulletin or UEFI firmware update that applies to
this error.
2. Power off the system and remove A/C power.
3. Restore A/C power and power on the system.
4. Determine if there have been recent changes to the hardware, firmware or operating system. Reverse
them if possible.
5. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0062F: System uncorrected recoverable error happened in Processor [arg1] Core [arg2]
MC bank [arg3] with MC Status [arg4], MC Address [arg5], and MC Misc [arg6].
Severity: Warning
Parameters:
[arg1]: Socket number, 1-based [arg2]: CoreNumber [arg3]: McBankNumber [arg4]: McaStatus [arg5]:
McaAddress [arg6]: McaMisc
User Action:
Complete the following steps:
1. Perform a virtual reseat or AC cycle the server.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU4033F: TPM Firmware recovery is in progress. Please DO NOT power off or reset system.
. 181
Chapter 3 UEFI events