Table of Contents
Advertisement
Optional Devices
Installing a memory module
There are slots for two memory modules, one over the other. The
procedures are the same for installing either module.
1. Set the computer to boot mode and turn the computer's power off.
Make sure the Power indicator is off. Refer to the
section in Chapter 3,
2. Remove AC Adaptor and all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack. Refer to
Replacing the battery pack
4. Loosen the screw securing the memory module cover. The screw is
attached to the cover to prevent it from being lost.
5. Slide your fingernail or a thin object under the cover and lift it off.
module cover
6. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 45 degree angle before
pressing it down until the latches on either side snap into place.
Align the grooves along the edges of the memory module with the locking
tabs on the connector and insert the module into the connector firmly. If
you find it difficult to install the memory module, gently prize the locking
tabs outwards using the tip of your finger. Ensure that you hold the memory
module along its left and right hand edges - the edges with the grooves in.
9-12
Getting
Memory
Screw
Removing the memory module cover
Slot A
Seating the memory module
Started.
section in Chapter 6, Power, for details.
Turning off the power
Slot B
User's Manual
Advertisement
Table of Contents
