Toshiba Portege M400 User Manual page 179

8. With the hard disk drive in a vertical position, lift it straight up and away
from the connector.
Plastic tab
Installing the HDD Kit (Serial-ATA)
To install the HDD Kit (Serial-ATA), follow the steps below.
1. Move the connector until it is vertical.
2. Hold the hard disk drive vertically with its label on the left.
3. Connect the hard disk drive to the connector.
Ensure that the hard disk drive is connected to the connector in a vertical
position. If the hard disk drive is slanted and connected to the connector, it
might damage the connector.
4. With the connector connected, lower the hard disk drive down to the
storage position.
Plastic tab
5. Seat the cover and press down until the latches click into place.
6. Secure the cover with two screws.
7. Turn your computer over.
User's Manual
Removing the hard disk drive pack
Installing the hard disk drive pack
Optional Devices
Connector
Hard disk
drive pack
Connector
Hard disk
drive pack
8-18