Table of Contents
Advertisement
If you do not want to use DHCP/BOOTP/RARP to assign an IP address
●
Select <Off>. If you select <DHCP> when these services are unavailable, the machine will waste time
and communications resources searching the network for these services.
4
Check that <Auto IP> is set to <On>.
●
If <Off> is selected, change the setting to <On>.
5
Select <Apply>.
●
IP addresses assigned via DHCP override the address obtained via Auto IP.
Manually entering an IP address
1
Select <Auto Acquire>, and select <Off> in <Auto Acquire>
2
Select <Manually Acquire>.
3
Enter <IP Address>, <Subnet Mask>, and <Gateway Address>, and select <Apply>.
5
Select <OK>.
6
Restart the machine.
Checking whether the settings are correct
●
Make sure that the Remote UI screen can be displayed with your computer (
UI(P. 427) ). If a computer is not available, you can check the connection by using the operation panel (
Testing the Network Connection(P. 34) ).
When you have changed the IP address after installing the printer driver
●
When the MFNP port is used, the connection is maintained as long as the machine and the computer belong
to the same subnet; therefore, you do not need to add a new port. When the standard TCP/IP port is used,
you need to add a new port.
*
If you do not know which port is used, see
Testing the Network Connection
1
Select <Menu> in the Home screen.
2
Select <Preferences>
●
If the login screen appears, enter the correct ID and PIN.
Setting Up
Restarting the Machine(P. 122)
Configuring Printer Ports(P. 45)
Checking the Printer Port(P. 695) .
Home Screen(P. 126)
<Network>.
34
<Apply>
<OK>.
Starting Remote
Logging in to the Machine(P. 137)
Advertisement
Table of Contents
