Listening To Radio Broadcasts Oes; Va Toutes Easaserpenaueetreaieiacnteanes; Irienna Er Sae Aaaea Tesasvonudanespaptineddenantacsererteataniee - Technics SA-EX 140 Operating Instructions Manual

Operations i a
Selected band |
tovpurvvoavvvvev vtvevvoupvasaoppanasasasasasnna (EEETETTTEETTTEET
'QUARTZ LOCKC STEREO
i
itn F
i ha DHG
ite
RQTS221
Listening to radio broadcasts
You can use the tuning buttons to tune-in radio broadcasts.
Press [TUNER].
Press [BAND] to select "FM" or "AM".
Press [TUNING {v} or {,)}] to tune to the desired
broadcast.
Tuning intervals FM: 0.2 MHz
AM: 10 kHz
"QUARTZ LOCK" lights up when tuned.
"STEREO" lights up when an FM stereo broadcast is
received.
To make an automatic search for broadcast stations
If [TUNING (v) or {A)] is held down for an instant until the fre-
quency begins to scroll, the broadcast stations can be tuned
in automatically when a broadcast station is found.
Tuning may stop automatically if any jamming is encoun-
tered.
If noise is excessive in the FM stereo mode
Press [FM MODE).
(The "STEREO? indicator will go out, and the "MONO" indicator will
light up.) .
The broadcast will be monaural, but noise will be reduced,
If the button is pressed once more, the stereo mode will be
resumed.
Direct tuning 2
(Only available from the remote control.}
Specify the frequency using the numbered buttons on the remote
-control transmitter to directly tune to the desired broadcast station.
First select between FM and AM with the [BAND] button on the
receiver.
Press [TUNER].
This will set the remote control to operate the tuner.
Press [DIRECT TUNING/DISC ENTER].
Press the appropriate numbered buttons to enter
the frequency, while cursor display is flashing.
Tuning intervals FM: 0.1 MHz
AM: 10 kHz
If the desired FM frequency is 107.9 MHz, press
W > 0- [27] [3]
If the frequency has been input correctly, the displayed fre-
quency will blink once.
1. If no button is pressed while the cursor display is flashing,
the display will return to the frequency which is currently
being received. To re-specify the frequency, repeat the
procedure from step 2.
2. if the frequency has not been input correctly, "ERROR"
will be displayed. In this case, re-enter the frequency.