Vcon Mediaconnect 6000, 8000 - Shure SM-02 Instructions Manual

VCON MediaConnect 6000 & 8000, Falcon IP / ISDN
Quick Setup Sheet
LINE
POWER LINE
OUT IN
A B A
1 2 3 4
1. Power supply connector
2. Line Output A – reserved for video codec
3. Line Output B – reserved for Premier telephone interface
4. Line Input A – reserved for video codec
5. Line Input B – reserved for Premier telephone interface
6. DB15F pins – connect microphones and speakers
7. Record Output – Line level connection for recording
8. Microphone send level adjust – set & forget
9. Speaker level adjustment – set & forget
10. Reserved for CTG table microphones – do not use this jack with ceiling microphones connected
Step 1: Connect Speakers and Microphones
Pinouts: 15 pin D Connector
pin 1: speaker 1+
pin 2: speaker 2+
pin 3: speaker 3+
pin 4: speaker 4+
pin 5: no connection
pin 6: mic 1ground
pin 7: mic 1-
pin 8: mic 1+
Step 2: Connection of Codec
•
Connect the LINE OUT A of the SM-02 to the MIC INPUT of the codec with the cable provided by
CTG.
•
Connect the LINE IN A of SM-02 to the LINE OUTPUT of the codec.
•
Connect POWER to the SM-02.
•
Echo cancellation should be enabled in the codec.
Step 3: Adjust the Send Level
•
With a screwdriver turn the SM-02 MIC ADJUST clockwise to the 10 o'clock position. If needed,
call a CTG technician to fine-tune the system levels.
•
Microphone muting should be performed through MediaConnect's on screen menus.
Step 4: Adjust the Receive Level
•
Set the SPEAKER VOLUME level on the SM-02 to the 2 o'clock position.
•
Use MediaConnect's on screen menus to raise or lower the incoming audio.
Page 27 of 29
MIC / SPEAKER RECORD
CONNECTIONS OUT
B
5 6 7
pin 9: speaker 1-
pin 10: speaker 2-
pin 11: speaker 3-
pin 12: speaker 4-
pin 13: mic 2 ground
pin 14: mic 2-
pin 15: mic 2 +
CTG Tech Support
904.880.5125 telephone
904.886.9578 / 2830 video (128K)
SPEAKER LEVEL
MIC MICROPHONE
ADJ
™
Soundman
8 9 10
27