Panasonic PV-L452 Service Manual page 197

12. Removal of CCD C.B.A., Filter Rubber, Optical Filter, IR
Cut Filter
CAUTION:
1) When removing the CCD C.B.A., take care that the
Optical Filter and the IR Cut Filter do not fall out.
2) Take extreme caution when removing the CCD C.B.A.
because it is easily damaged by static electricity. Use
a Wrist Strap while removing and installing.
3) Do not touch the CCD window surface.
Installation of CCD C.B.A., Filter Rubber, Optical Filter,
IR Cut Filter
1) Install the IR Cut Filter in the Lens Unit correctly.
Note: Make sure no dust gets on the IR Cut Filter or in
the Lens Unit. Clean the IR Cut Filter with lens cleaning
paper dampened with lens cleaner if necessary.
2) Install the Optical Filter on the IR Cut Filter correctly.
Note: Make sure no dust gets on the Optical Filter or in
the Lens Unit. Clean the Optical Filter with lens cleaning
paper dampened with lens cleaner if necessary.
3) Install the Filter Rubber on the Optical Filter correctly as
shown below.
Note: Make sure that no dust gets on the Filter
Rubber.
4) Install the CCD C.B.A. in the Lens Unit. Then, secure
the 2 Screws (502) while keeping the CCD C.B.A.
pressed toward the upper right corner.
Note: Do not touch the Lens Surface. Clean the surface
with lens cleaning paper dampened with lens cleaner if
necessary.
13. Installation of Zoom Motor Unit
Install the Zoom Motor Unit so that the Shaft of the Zoom
Motor Unit is set in the Holder. Then, tighten the 2 Screws
(501).
14. Installation of Top Operation Unit
1) Install the Top Operation Unit to the Side Case R Unit
while setting the Locking Tab (L-2).
2) Then, secure the 2 Locking Tabs (L-1).
15. Installation of Battery Catcher Unit
1) To remove the Battery Catcher Unit, first remove the
Backup Cover (29) with the Battery.
2) Remove the 2 Screws (533, 586).
3) Release the 3 Locking Tabs (L-3). Then, slide the
Battery Catcher Unit out by pushing Portions A and B as
indicated by the arrow.
WARNING:
DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED. REPLACE ONLY WITH
THE SAME OR EQUIVALENT TYPE.
(L-3)
Portion A
Push
Push
16. Replacement of Lamp
When replacing the Lamp, refer to "HOW TO REPLACE
THE LAMP" in "SERVICE NOTES."
DANGER:
Use only replacement Lamp (PART NO. VLLW0015)
supplied by Panasonic to reduce risk of fire.
Handle new Lamp with cloth or tissue as skin oils will
decrease Lamp life.
Remove Light Protector and allow Lamp to cool before
replacing to avoid possible burn hazard.
(L-3)
Battery
Catcher
Unit
Slide
Battery
Catcher
Unit
Portion B
Fig. D9