Date/Clock Setting - Hitachi VM-2300A Instruction Manual

DATE/CLOCK SETTING
1. Load the camera/recorder's date/clock battery as
described on page 8. '
. Turn on power of camera/recorder.
. Slide "VCR/CAM" select switch to "CAM".
. Press "DATE/TIME" button.
Date and time appear in the viewfinder and "1"
flashes.
BO Nh
1:00AM
¥,
WY 17390
5. Press "SET" button to select correct month. Hold
button down to advance rapidly. When the correct
month appears, press "SHIFT" button.
12:00AM
17 ZIv80
6. Press "SET" button to select correct date. Hold -
button down to advance rapidly. When the correct
date appears, press "SHIFT" button.
E22
PUSH-AUTO
Se
DISPLAY RESET MEMORY REVIEW TITLE
NEGAs+POSI INDEX
bi Gz
ON/OFF DATE/TIME
"SET" Button
"SHIFT" Button
"DATE/TIME" Button
MAN ®e AUTO
7. Press "SET" button to select year, and then press
"SHIFT" button.
vA,
plEgQOAM
117 5/30
8. Press "SET" button as many times as may be re-
quired to select correct hour, and then press
"SHIFT" button.
9. Repeat steps 8 to select minute and AM/PM.
6:30AM
117 5/90
10. After setting AM or PM, press "SHIFT" button
again to erase the flashing cursor and start the
internal clock.
NOTE:
¢ To correct date/clock information during pro-
gramming or after starting the date/clock, press
"SHIFT" button until the incorrect digit is flashing.
Then use "SET" button to enter the correct digit.
e The date/clock graphics will be recorded whenever
they appear in the viewfinder. To display date and
clock together, press "DATE/TIME". To display
date only, press "DATE/TIME" again. Pressing
"DATE/TIME" a third time removes both graphics.