Table of Contents
Advertisement
@ WHEN
USING WITH THE CAR BATTERY (By using optional car battery cord Hitachi VM-CC70A)
To cigarette lighter
1. Connect the small plug of the car battery cord to the
"DC IN 9.6V" jack of the camera/recorder.
2. Connect the other end of the car battery cord to the
car's cigarette lighter socket.
CHECKING THE BATTERY
When the "E" indication in the viewfinder appears and
flashes while the camera/recorder is operated with a
battery (Accessory No. 2) during recording, it indicates
that the battery charge is insufficient.
Then, charge it
or replace it with a charged battery.
NOTE: Whenever the linear time counter or time re-
maining display is present in the viewfinder, it appears
with a 3-dash
read-out
indicating
the condition
of
camera/recorder battery power.
When the battery is
fully charged, the display reads ""E———F".
When the battery is very near empty, only one dash re-
mains and starts blinking.
You should find an alterna-
tive power
source
or recharge
the battery
before
continuing to use your camera/recorder.
E10
NOTES:
e The car battery cord is designed to be used only
with automobiles
having
a 12-volt
negative
ground system.
To avoid possible damage to your camera/
recorder, make sure the car battery cord you
plan to use has positive tip polarity and is
capable of converting 12 volts to 9.6 volts such
as Hitachi model VM-CC70A.
Advertisement
Table of Contents
