Table of Contents
Advertisement
TIME REMAINING
When the linear time counter is present in the view-
finder, pressing "DISPLAY" button again will change
the display to a read-out showing the amount of record-
ing or playback time left on the tape.
Pressing "'DIS-
PLAY" button once more clears all graphics from the
viewfinder.
NOTE: When using an extended length T-160 cassette,
you must press ""RESET/T-160" button to adapt the
camera/recorder's time remaining system for an accu-
rate read-out.
(If the counter
is being
displayed,
"RESET/T-160"
button
resets
the
counter
to
*0:00:00°'.)
SELF TIMER
The self timer allows you to automatically start record-
ing after about ten seconds.
Press "SELF TIMER" switch once while in the record/
pause mode.
The camera/recorder will automatically start recording
after ten seconds when the switch is pressed and will
continue to record for approx. 30 seconds.
If you press the "SELF TIMER"
switch twice, the
camera/recorder will automatically start recording after
ten seconds
when
the switch
is pressed and then
recording
will continue
until the record
start/stop
button or "STILL (REC/PAUSE)" button is pressed.
NOTES:
© Record indicator flashes for about 10 seconds to in-
dicate
self timer
mode
when
you
press "SELF
TIMER" switch and stays on during recording.
¢ Pressing "SELF TIMER" switch a third time before
recording starts releases the self timer mode.
* To
stop
the
camera/recorder
during
self timer
recording, press record start/stop button or "STILL
"RESET/T-160" Button
"DISPLAY" Button
"STILL (REC/PAUSE)" Button
"SELF TIMER" Switch
(REC/PAUSE)"
button and the camera/recorder
will enter the record/pause (stand-by) mode.
¢ The "SELF TIMER"
switch has no effect during
normal recording.
NEGATIVE/POSITIVE INVERSION
© Normally set to "POSI''.
¢ Set to "NEGA" for special effects.
Positive picture
Negative picture
E28
"NEGA/POSI" Switch
; NOTE: Always return the switch to""POSI" after
«292°
shooting with
the switch set to "NEGA'.
Advertisement
Table of Contents
