Managing System Switch - Honeywell TC300 Configuration And User's Manual

4 - CONFIGURATION
To configure Control sensors
The thermostat groups the control sensors into three types. There are Local sensor,
Remote sensor, and Multi sensor.
Local Sensor: Internal TC300 temperature sensor. Installer can configure offsets to
on-board temperature and humidity sensors, if desired.
Remote Sensor: Space temperature sensor connected to UI/UIO terminal, or TR40
sensor configured at address 2.
Multi Sensor: Local Sensor and Sylk sensors at address 2, 3, 4, 5 used together to
calculate space temperature.
1. Swipe left from the Home screen.
2. On the Quick access screen, tap
The Control sensors screen appears. By default, it shows Local Sensors. If Remote
Sensors are also configured then Multi-Sensors and Remote Sensors also appear.
Note: If the relevant sensors not available then it will be grayed out.

Managing System switch

To configure system switch
1. Swipe left from the Home screen.
2. On the Quick access screen, tap
The System switch screen appears.
64
> Equipment > Sensor Settings > Control Sensors.
Figure 43 Control sensors
> Equipment > System Switch.
Managing System switch