Table of Contents
Advertisement
5. Enable Daylight Savings if required.
6. If Daylight saving is enabled, set the start and end date schedules for daylight savings.
7. Tap the back button to navigate back to the previous screen.
To enable screen cleaning mode
Screen cleaning mode lock/disable the touch sensitivity of the display for 30
seconds so you clean the device display while the thermostat is functional.
1. Swipe left from the Home screen.
2. On the Quick access screen, tap
The Screen Cleaning screen appears.
3. Tap OK to enable the screen cleaning mode for 30 seconds or tap the back button to
navigate back to the previous screen.
To configure override setting
This is to allow the user to configure the override settings. There are two types of
override settings available.
Permanent Override - This provides schedule for 24/7 fixed setpoint control (No
occupied, standby periods).
Temporary Override - This allows authorized user to adjust setpoint or operating
mode for fixed interval that deviates from standard schedule.
The override occurs when the user manually changes the setpoint on the thermostat
screen. This overcomes the current mode from Occupied/Unoccupied/Standby to
temporary mode.
1. Swipe left from the Home screen.
2. On the Quick access screen, tap
The Override Setting screen appears.
Basic configuration
> Basic > scroll down > Screen Cleaning.
Figure 23 Screen cleaning
> Basic > scroll down > Override Setting.
BASIC CONFIGURATION
47
Advertisement
Table of Contents
