TO CHANGEBLADE
DEPTH
See Figure 28.
The blade depth should be set so that the outer points of
the blade are higher than the workpiece by approximately
1/8 in. to 1/4 in. but the lowest points (gullets) are below
the top surface.
[] Raise the blade by turning the height/bevel
adjusting
handwheel clockwise or lower it by turning the hand-
wheel counterclockwise.
GULLET
TO ADJUST
THE BEVEL
INDICATOR
See Figure 30.
If the bevel indicator is not at zero when the saw blade
is at 90 ° , adjust the indicator by loosening the screw and
setting it at 0 ° on the bevel scale. Retighten the screw.
LJ
BEVEL
LOCKING
LEVER
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
SCREW
Fig. 28
TO CHANGE
BLADE
ANGLE
(BEVEL)
See Figured 29 - 30.
NOTE: A 90 ° cut has a 0 ° bevel and a 45 ° cut has a 45 °
bevel.
[] Loosen bevel control by pulling the bevel locking lever
all the way to the right.
[] Adjust the bevel angle by pushing the wheel in toward
the saw then turning it. Turning the wheel counter-
clockwise increases the angle of the blade, bringing it
closer to 45 ° . Turning it clockwise decreases the angle,
bringing the blade closer to 90 ° .
[] Tighten bevel control by pushing the bevel lock lever to
the left.
BEVEL
INDICATOR
ODECREASE
ANGLE
ANGLE
Fig. 29
26
Fig. 30