Table of Contents
Advertisement
Objects in the travel path of the pedals
Warning
Objects in the driver's footwell can limit the
pedal travel or block a depressed pedal.
There is a risk of accident. Stow objects in the
vehicle such that they are secured and can-
not enter into the driver's footwell. Use floor
mats that are suitable for the vehicle and
can be safely attached to the floor. Do not
use loose floor mats and do not layer several
floor mats. Make sure that there is sufficient
clearance for the pedals. Ensure that the floor
mats are securely fastened again after they
were removed, for instance for cleaning.
Pedal feel when driving off
After turning on drive-ready state from idle
state, the pedal may feel unusual, e.g., the
pedal travel path may feel short or long. After
the brake pedal has been fully released, the
pedal will feel as usual again.
Driving in wet conditions
In case of wet roads, exposure to road salt or
in heavy rain, gently depress the brake pedal
every few kilometers.
Ensure that this action does not endanger
other road users.
The heat generated while braking dries brake
disks and brake pads and protects them
against corrosion.
In this way the brake power will be available
when you need it.
Hills
General information
Drive long or steep downhill gradients in the
gear that requires least braking effort. Other-
wise, the brake system may overheat and re-
duce braking effect.
Things to remember when driving
Online Edition for Part no. 01405A8A5A2 - VI/23
You can increase the engine braking effect by
downshifting, going all the way to first gear, if
needed.
Safety information
Warning
Light but consistent pressure on the brake
pedal can lead to high temperatures, brake
wear and possibly even brake system failure.
There is a risk of accident. Avoid placing ex-
cessive stress on the brake system.
Warning
In Neutral or with drive-ready state switched
off, safety functions, for instance engine brak-
ing effect, braking assistance and steering
assistance, may be restricted or not availa-
ble. There is a risk of accident. Do not at-
tempt to drive in idle state or with drive-ready
state switched off.
Brake disk corrosion
Corrosion on the brake disks and contamina-
tion on the brake pads are increased by the
following circumstances:
▷
Low mileage.
▷
Extended stationary periods.
▷
Infrequent use of the brakes.
▷
Aggressive, acidic, or alkaline cleaning
agents.
Corrosion buildup on the brake disks will cause
a pulsating effect on the brakes when braking
slowly - generally this cannot be corrected.
Condensation water under the
parked vehicle
When using the automatic climate control, con-
densation water develops and collects under-
neath the vehicle.
DRIVING TIPS
305
OwnersManuals2.com
Advertisement
Table of Contents
