Table of Contents
Advertisement
12. Remove the packaging material from the bottom
of the Frame (56). See the inset drawing. Make
sure that the 1/2" Rear Foot Nuts (111) are
threaded all the way onto the Rear Feet (60).
Turn the two Rear Feet all the way into the
Frame.
See step 10. Discard the piece of cardboard.
Lower the Frame (56) (see HOW TO LOWER
THE TREADMILL FOR USE on page 24).
If one of the Rear Feet (60) doesnʼt sit flat on the
floor, turn the Rear Foot until it does and then
tighten the 1/2" Rear Foot Nut (111) against the
Frame (56).
13. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to
adjust the walking belt (see pages 26 and 27).
12
56
60
111
60
12
56
60
Advertisement
Table of Contents
