Removing The Processor Module - Dell P07T002 Service Manual

Back to Contents Page
Processor Module
Dell™ Inspiron™ N5020/M5030 Service Manual
Removing the Processor Module
Replacing the Processor Module
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
is not covered by your warranty.
CAUTION:
surface (such as a connector on your computer).
CAUTION:
computer.
Removing the Processor Module
1. Follow the instructions in
2. Remove the battery (see
3. Remove the keyboard (see
4. Remove the palm rest (see
5. Remove the processor heat sink (see
CAUTION:
to apply slight pressure to the center of the processor while turning the cam screw.
CAUTION:
6. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
1 ZIF socket
3 ZIF-socket cam screw
CAUTION:
oils in your skin can reduce the heat transfer capability of the thermal pads.
CAUTION:
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
To help prevent damage to the system board, remove the main battery (see
Before You Begin.
Removing the Battery).
Removing the Keyboard).
Removing the Palm Rest).
Removing the Processor Heat
To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press
To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.
2 pin-1 corner
To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly. The
When removing the processor module, pull the module straight up. Be careful not to bend the pins on the processor module.
UserManuals.info
Removing the Battery) before working inside the
Sink).