Before You Begin; Recommended Tools; Turning Off Your Computer; Before Working Inside Your Computer - Dell P07T002 Service Manual

Back to Contents Page
Before You Begin
Dell™ Inspiron™ 1120 Service Manual
Recommended Tools
Turning Off Your Computer
Before Working Inside Your Computer
This manual provides instructions for removing and installing components in your computer. Unless otherwise noted, each procedure assumes that the
following conditions exist:
You have performed the steps in
l
You have read the safety information that shipped with your computer.
l
A component can be replaced or—if purchased separately—installed by performing the removal procedure in the reverse order.
l
Recommended Tools
The procedures in this document may require the following tools:
Phillips screwdriver
l
Small flat-blade screwdriver
l
Plastic scribe
l
BIOS executable update program available at support.dell.com
l
Turning Off Your Computer
CAUTION:
1. Save and close all open files and exit all open programs.
2. Shut down the operating system:
Click Start
3. Ensure that the computer is turned off. If your computer did not automatically turn off when you shut down the operating system, press and hold the
power button until the computer turns off.
Before Working Inside Your Computer
Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your own personal safety.
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
not covered by your warranty.
CAUTION:
mounting bracket. Hold a component by its edges, not by its pins.
CAUTION:
tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep
them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented
and aligned.
CAUTION:
1. Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.
2. Turn off your computer (see
CAUTION:
3. Disconnect all telephone or network cables from the computer.
Great user manuals database on

Turning Off Your Computer

To avoid losing data, save and close all open files and exit all open programs before you turn off your computer.
and then click Shut Down.
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal
When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking
To avoid damaging the computer, perform the following steps before you begin working inside the computer.
Turning Off Your Computer) and all attached devices.
To disconnect a network cable, first unplug the cable from your computer and then unplug the cable from the network device.
UserManuals.info
and Before Working Inside Your Computer.