Furuno GP-3500F-D Operator's Manual page 32

1. BASIC OPERATION
Entering character
1. Roll the trackball in up-down direction to select the first alphanumeric
character with the cursor (red square).
Numeric may also be entered by pressing numeric key.
2. Press the [ENTER] knob.
Note: If you enter a wrong character, move the cursor to that location and then
re-enter the proper character. To move the digit cursor, select ◄ and then
press the [ENTER] knob for left direction, or select ► and then press the
[ENTER] knob for right direction.
Press the [CLEAR] key to erase the all characters.
3. Repeat steps 1 and 2 to complete the naming.
4. Finally, select "END" and then press the [ENTER] knob.
1-20
PASSWORD ENT AGAIN
A B C D E F G H I J
Z , - ! ? / & ^ = #
a b c d e f g h i j
z _ _ _ _ _ _ _ _ _
SELECT ALPHANUMERIC CHARACTER BY TRACKBALL AND PRESS KNOB
TO ENTER. OR PRESS NUMERIC KEY TO NAME WAYPOINT.
MOVE THE CURSOR TO "END" ONCE THE EDITION IS FINISHED.
Ex. Set password, entering characters
Digit cursor
K L M N O P Q R S T
1 2 3 4 5 6 7 8 9 0
k l m n o p q r s t
_ _ _ _ _ _ _ _ _ _ _
Cursor
END
U V W X Y
_ _ _ _ _
u v w x y
_ _ _