Cable Tie Condition Factors; Tie In Tool" Addendum - Panduit PDM Operation Manual

© Panduit Corp. 2013
Error Message
Dispenser Jam - Check Tie
Loading
Jaw Sensor Error
Detent Sensor Blocked or Dirty
Blocked Hose - Failed Back
Pressure Test
12A: Cable Tie Condition Factors
INCORRECT CABLE TIE
CUT-OFF
(Long cut-off / tail)
• Cable ties are too moist
(due to high humidity)
- Turn down tension until correct cut-
off occurs.

13: "TIE IN TOOL" ADDENDUM

Turning new "Tie in Tool" feature "ON" or "OFF"
Level 1 - Operator Menu ("Load, Unload, Menu" Display)
Loads: 14
Load Unload
Level 1B - Loading commands disappear
OPERATION MANUAL
a. Press "Buzzer" button, open Dispenser door, Press
"Unload" button while pulling back lightly on strip of cable
ties until all cable ties are removed. Cut off bad cable ties
and reload.
b. If having trouble clearing jam, contact Maintenance
Department. (Note: Don't pry on white plastic roller; will
cause damage.
Contact Maintenance Department
CORRECT CABLE TIE
CUT-OFF
XXXXXXX
MENU
XXXXXXX
MENU
Page: 38 of 39
PAT1M, PAT1.5M, PDM
ENGLISH
Corrective Action
CABLE TIE DETACHES
FROM BUNDLE
• Cable ties are too brittle
(due to dry conditions)
- Take new reel of ties out of
original bag.
- Place new ties on PDM.
- Place used reel in bag with
damp paper towel or
sponge to recondition.
From either of these screens,
Press the MENU button