Replacing The Pump - Craftsman 118.22000 Operator's Manual

I
I
I
I
REPLACING THE PUMP
Only use identical replacement parts, available at your Sears Parts and Repair
Center. To locate a Sears Parts and Repair Store near you, call the 800 number
located on the back of this manual.
1. Remove the water tray from the saw table. Remove pump from housing in water
tray. Set tray aside. Loosen knob on black cover box under saw table (Fig. 35).
Remove cover box and disconnect pump plug from the socket (Fig. 36). Remove
tube from water pump discharge fitting (Fig. 37).
2. Replace the old pump with the new one, carrying out the above operation in
reverse order.
PROBLEM
The motor
is hot.
The machine
does not work.
Water does not
flow at the blade
with the pump
running.
Motor gives off
unpleasant odor.
Machine is
difficult to start.
22
CAUSE
The ventilation slots in the motor
are clogged with dirt
The motor is defective
The power supply cord is
damaged or not properly
connected.
No voltage in socket, or circuit
breaker is off.
The switch is broken.
Check water level
Water tube from pump may be
clogged
The sprayer is clogged.
Water may have seeped through
inside of motor.
Motor bearings are damaged.
SOLUTION
Clean the ventilation slots
Have your machine repaired
at a Sears Service Center
Press the plug firmly into the
power socket.
Check the power supply cord.
Reset the circuit breaker.
Have your machine repaired
at a Sears Service Center.
Add water if needed.
Disconnect tube and clean
out.
Dismantle the sprayer and
remove any residuals.
Unplug the power cable and
consult your local Sears
Service Center.
Unplug the power supply
cable and consult your local
Sears Service Center.
23
I
I
I
I
1-19-06