Installation Requirements; Tools And Parts - Thermador KBULT3655E Installation Instructions Manual

Side Trim
"
(9.7 mm)
"
(1.5 mm)
"
(3.2 mm)
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add " (0.8 mm) to this measurement to allow the side
panel to fit into the trim.
To o l s a n d Pa r t s
IMPORTANT:
Installer: Leave Installation Instructions with the homeowner.
Homeowner: Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
Tools needed:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Hand drill or electric drill
(properly grounded)
Drill bits
Adjustable wrenches (2)
Phillips screwdriver
Small level
Appliance dolly
†®TORX is a registered trademark of Textron Innovations Inc.
12
"
(4.5 mm)

INSTALLATION REQUIREMENTS

®†
T27 Torx screwdriver
" nut driver
" and " open-end
wrenches
" Allen wrench
" socket wrench
Tape measure
2. If the panel is more than
edge to allow the side panel to fit into the trim.
A
Recessed Inset Installation Dimensions
1. Measure the distance from point A (as shown) to back wall.
2. Route the front edge of the support board or attach a
(9.5 mm) board to hold the panel in the cabinet side trim.
A
Parts needed:
#8 x 3" (7.6 cm) or longer wood screws (6)
2" x 4" x 32" (5 cm x 10 cm x 81 cm) wood board (1 or 2)
Make custom or overlay panels or consult a qualified
cabinetmaker or carpenter to make the panels. See "Design
Specifications."
If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, and a
" (6.35 mm) compression fitting.
" (9.5 mm) thick, route the front
"