Installing The System Board - Dell OptiPlex 3010 Small Form Factor Owner's Manual

11. Remove the 7–mm hex screw that secures the system board to the chassis.
12. Slide the system board towards the front of the computer.
13. Remove the system board from the chassis.
Related Links

Installing the System Board

Installing The System Board
1. Align the system board to the port connectors on the rear of the chassis and place the system board in the chassis.
2. Tighten the 7–mm hex screw securing the system board to the chassis.
3. Tighten the screws securing the system board to the chassis.
4. Close the expansion card latch.
5. Connect the cables to the system board.
6. Connect the intrusion switch cable, SATA cables, Input/Output board cable, system fan cable, power switch cable,
internal speaker cable, and the power supply cables to the system board.
7. Install the fan shelter.
8. Install the heat sink and processor.
29