Next steps
1. Replace the
battery
2. Replace the
base cover
3. Replace the
SD memory card
4. Follow the procedure in
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
2. Remove the
SD memory card
3. Remove the
base cover
4. Disconnect the battery cable from the connector on the system board
5. Remove the
WLAN
6. Remove the
hard drive assembly
Steps
1. Peel off the tape securing the wireless antenna from the system board [1].
2. Unroute the display cable from the routing guides on the palmrest and keyboard assembly [2].
3. Unroute the display cable from the routing guides on the palmrest and keyboard assembly [3, 4].
46
Removing and installing components
after working inside your computer
before working inside your computer