On-Off Switch - Craftsman 113.225909 Owner's Manual

assembly
5. Place belt over machine pulley and insert the belt nl
the open end of the guard and out the round opening.
MAKE SURE BELT HAS NOT SLIPPED OFF OF
MACHINE PULLEY FROM STEP 3, DISC AND
DUST TRAP INSTALLATION.
/
/
BELT
6. Place the bolt onto the motor pulley by rotating the
pulley,
7. Move the motor sideways so that the belt is in the
center of the opening in the top of the base. Visually
line up the pulleys and V-belt.
8. PUSH downward on motor to apply tension to belt and
tighten motor bolt nuts.
9. Check guard support before tightening guard support
screws. Guard support must becentered around motor
shaft, Tighten screws.
10. Push guard into position on guard support.
r •
I
/ /
/
IELT MUST BE ON
MACHINE PULLEY
ON-OFF SWITCH
WARNING: DON'T CONNECT POWER CORD TO
ELECTRICALOUTLET IN YOU R SHOP UNTIL YOU ARE
SURE MOTOR ROTATION IS CORRECT. SEE PAGE 5,
The On-Off Switch has a locking feature. THIS FEATURE IS
INTENDED TO PREVENT UNAUTHORIZED AND POSSIBLE
HAZARDOUS USE BY CHILDREN AND OTHERS.
1. Insert key into switch, _
NOTE: Key is made of yellow plastic
12