Installing Sanding Disc And Dust Trap - Craftsman 113.225909 Owner's Manual

1. )lace the 3elt and Disc Sander on the Steel Legs,
position as shown, ane align the mounting qoles n
the feet of the Belt and Disc Sander with those in the
END STIFFENERS marKea with an X n tne
Jllustratior !.
2. Mount to legs using two 5_16-18 x 2-1/2'" hex head
screws, flat washers, externa! Iockwashers. ana hex
nuts.
NOTE: The abrasive belt is shipped detached. To
install the belt on the machine:
1. Loosen both belt LOCKING screws, using the 1/2"
wrench furnished with the machine.
2. Turn both of the abrasive belt AJUSTING screws as
shown until they stop. Retighten the two belt LOCK-
ING screws so that the idler pulley does not come out
3. Remove the piece of paper,
4. Remove the protective coating, that is applied at the
factory, from the belt table. Use any ordinary house-
hold type grease and spot remover.
WARNING: Never use gasoline, naptha, or similar
highly volatile solvents.
NOTE: Do not apply wax to the belt table.
1/2" WRENCH
/
BELT ADJUSTING SCREW
(ONE ON EACH SIDE)
INSTALLING SANDING DISC AND DUST
TRAP
1. Loosen the belt table locking bolts behind the mount-
ing bracket using one of the 1/2"" wrenches supplied
with your machine.
2. Position belt table vertically and tighten only one of
the bolts.
3. Place the V-Belt over the pulley.
4. Attach the switch assembly to the base using the two
screws and washers packed with the switch.
5. Loosen the bolt that you tightened in step 2. Position
the belt table horizontally, and tighten both bolts.
BELT TABLE LOCKING
WRENCH
SWITCH
ASSEMBLY