Settingup; Installing Th E Batteries - Nikon SB-10 Instruction Manual

SETTING UP
6
Install ing the Batteries
Power is supplied by four 1.5V AA-type bat-
teries. To install the batteries, first depress
the knurled surfaces on the top and bottom of
the unit. The Battery Holder MS-2 will then
pop out at the side . Next, I ift out the holder
and insert four batteries, making sure that
the positive and negative
(+
and - ) terminals
are installed according to the diagram inside the
ho lder . To replace the battery holder, slip it
into the battery compartment until it clicks
into place . If you foresee not using your speed-
light for some time, it is advisable to remove
the batteries for separate storage . This will eli-
minate the risk of damage caused by leaking
batteries .