Philips 32HFL5662L/F7 Service Manual page 13

3
1
1
2
Figure 4-5 Smart module board removal [1/2]
Figure 4-6 Smart module board removal [2/2]
4.3.3 Smart module board without removed rear cover
Refer to Figure 4-7, Figure 4-8
Caution: If only the smart module board needs to be removed
from the set, follow the below method to remove it. It is
mandatory to remount all different screws at their original
position during re-assembly. Failure to do so may result in
damaging the smart module board.
1. Remove the fixation screws [1], [2], [3] that secure the
smart module board cover, then remove it from the rear
cover. Refer to Figure 4-7
2. Remove fixation screws [1] that secure the smart module
board connector with the back-end board. Remove fixation
screws [2] that secure the smart module board.
Caution: When fixation screws [2] are removed first, the
smart module board connector can be damaged. Refer to
Figure 4-8 for details.
3. Pull out the smart module board horizontally until it is fully
disconnected from the back-end board.
Caution: Do not lift up the smart module board before it is
completely disconnected from the back-end board. Both
boards could be damaged. Do not damage the EMC foam
at the bottom side of the smart module board metal shield.
When defective, replace the whole unit.
2
2
Pull out
18880_104_101014.eps
18890_105_100916.eps
and Figure 4-9.
for details.
Mechanical Instructions
2
2
2
101014
Figure 4-7 Smart module board removal [1/3]
101014
Figure 4-8 Smart module board removal [2/3]
TPB1.1HU LA
3
3
2
3
2
1
Pull out
1
2
4. EN 13
2
1
1
3
2
18880_105_101014.eps
101021
2 2
2
18880_106_101014.eps
101021
2010-Nov-05