Related Manuals for Philips 32HFL5332
Summary of Contents for Philips 32HFL5332
- Page 1 Register your product and get support at www.philips.com/welcome User Manual 32HFL5332/97 37HFL5382/97 42HFL5382/97...
-
Page 3: Table Of Contents
Activating the Professional mode setup menu Professional mode options 8 Connect devices Back connectors Side connectors Connect a computer Use Philips EasyLink Use a Kensington lock 9 Product information Supported display resolutions Multimedia Tuner / Reception / Transmission Remote control... -
Page 4: Notice
1 Notice 2010 © Koninklijke Philips Electronics N.V. All rights reserved. Specifications are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N.V or their respective owners. Philips reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly. -
Page 5: Important
TV. If liquids are spilt on or into the TV, disconnect the TV from the power outlet immediately. Contact Philips Consumer Care to have the TV checked before use. • Never place the TV, remote control or batteries near naked flames or other heat sources, including direct sunlight. -
Page 6: Screen Care
Risk of injury, fire or power cord damage! • Never place the TV or any objects on the power cord. • To disconnect the TV power cord easily from the power outlet, ensure that you have full access to the power cord at all times. -
Page 7: Your Tv
3 Your TV Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your TV at www.philips.com/welcome. This section gives you an overview of commonly used TV controls and functions. Please read section 3 to 6 to set the basic... -
Page 8: Remote Control
Remote control (Standby-On) • Switches the TV to standby if it is on. • Switches on the TV if it is in standby. b MENU Toggles the main menu on or off. c TELETEXT Toggles teletext on or off. Note •... - Page 9 l CH +/- (Channel +/-) Switches to the previous or next channel. When the TV menu is on, this functions as Page Up / Down. When PBS setup menu is on, it switches to the previous or next channel or source.
-
Page 10: Use Your Tv
4 Use your TV This section helps you perform basic TV operations. Switch your TV on / off or to standby To switch on • If the standby indicator is off, press (Power) at the side of the TV. • If the standby indicator is red, press (Standby-On) on the remote control. -
Page 11: Watch Connected Devices
Watch connected devices Note • Switch on the device before selecting it as a source on the TV. Use the source button SOURCE. Press » The source list appears. Press to select a device. Press OK to confirm your choice. »... -
Page 12: Use More Of Your Tv
5 Use more of your TV Access TV menus Menus help you to install channels, change picture and sound settings and access other features. Press MENU > [PBS Settings] > [Consumer Setup] > [Yes]. » The consumer menu appears. Smart picture Picture Video contrast Sound... - Page 13 Manually adjust picture settings Press MENU > [PBS Settings] > [Consumer Setup] > [Yes]. » The consumer menu appears. Select [Picture] and press OK. Press to select the following settings. [Smart picture]: Accesses pre-defined • smart picture settings. • [Video contrast]: Adjusts the intensity of video contents, keeping backlight unchanged.
- Page 14 Change picture format FORMAT. Press » A picture format bar appears. Press to select a picture format. » The selected picture format is activated. Press OK to confirm your choice. Summary of picture formats The following picture settings can be configured.
-
Page 15: Use Advanced Teletext Features
Manually adjust sound settings Press MENU > [PBS Settings] > [Consumer Setup] > [Yes]. » The consumer menu appears. to select [Sound] and press Press Press to select the following settings. • [Smart sound] : Accesses pre-defined smart sound settings. •... -
Page 16: Create And Use List Of Favorite Channels
Select T.O.P. teletext broadcasts Table Of Pages (T.O.P.) teletext broadcasts allow you to jump from one subject to another without using page numbers. T.O.P. teletext is not broadcast on all TV channels. Press TELETEXT. » The teletext screen appears. INFO. Press »... -
Page 17: Use The Tv Clock
Remove a channel from a favorite list When watching TV, press OK. » The channel grid appears. Press to select a channel to remove. OPTIONS. Press Select [Unmark as favorite], then press » The channel is removed from the favorite list. Use the TV clock You can display a clock on the TV screen. -
Page 18: Use Tv Locks
Automatically switch the TV on (on timer) You can switch on the TV from standby to a specific channel at a specified time. Press MENU > [PBS Settings] > [Consumer Setup] > [Yes]. » The consumer menu appears. Press to select [Features] > [On timer]. -
Page 19: View Photos And Play Music From A Usb Storage Device
USB storage device Caution • Philips is not responsible if the USB storage device is not supported, nor is it responsible for damage or loss of data from the device. Use the USB connector to view photos or listen to music stored on a USB storage device. -
Page 20: Update The Tv Software
Press Wait for five seconds then disconnect the USB storage device. Update the TV software Philips continuously tries to improve its products and we recommend that you update the TV software when updates are available. Check www.philips.com/support for availability. Check the current software version Press MENU >... -
Page 21: Change Tv Preferences
Download the software On your PC, open a web browser and go to www.philips.com/support. Download the latest software upgrade file to your PC. Decompress the ZIP-file. Copy the autorun.upg file to the root directory of the USB device. Update using a USB device Connect your USB device to the USB port at the side of your TV. -
Page 22: Install Channels
6 Install channels The first time you set up your TV, you are prompted to select a menu language and to install TV and digital radio channels (if available). This chapter provides instructions on how to re-install and fine tune channels. Automatically install channels This section describes how to search and store channels automatically. - Page 23 Step 2 Search and store new TV channels Press MENU > [PBS Settings] > [Consumer Setup] > [Yes]. » The consumer menu appears. Press to select [Installation] > [Channel installation] > [Analog: manual install]. » The [Analog: manual install] menu appears.
-
Page 24: Rename Channels
Rename channels You can rename channels. The name appears when you select the channel. When watching TV, press OK to display the channel grid. Press to select the channel to rename. OPTIONS. Press » The channel options menu appears. to select [Rename channel], Press then press OK. -
Page 25: Professional Mode Instruction
7 Professional mode instruction Introduction Included in this TV is a special functional mode that allows the TV to be configured for commercial application. This feature is called Professional mode. This section has been designed to help install and operate this TV in Professional mode. Before reading this section, please read section 3 to 6 to set the basic functionality of this TV. -
Page 26: Activating The Professional Mode Setup Menu
Activating the Professional mode setup menu Switch on the TV and select a TV channel. Press the following buttons to access Professional mode setup menu: • [3, 1, 9, 7, 5, 3+ ¬(MUTE)] on Guest remote control. • M button on Professional setup remote control. -
Page 27: Professional Mode Options
Professional mode options This paragraph describes the functionality of each item in the Professional mode setup menu. Layer 1 Layer 2 PBS Mode Consumer Setup PBS Settings Store Reset Maximum volume Picture format Power on Switch on Setting Smart power Switch on Vol Switch on Ch Display message... - Page 28 Layer 1 Layer 2 TV Speaker Enable Speaker Settings Bathroom Speaker Volume Blank Channel Installation Multi RC Smart RC PayTV Setup USB to TV Smart Clone TV to USB Layer 3 Off / On 0 ~ 10 Off / On Blue / Off Green Yellow...
- Page 29 PBS settings [PBS Mode] Enables / disables the Professional mode. • [On]: All settings in the Professional mode Setup menu are in effect. • [Off]: The TV operates as a normal (consumer) TV. [Consumer Setup] A shortcut to enter the full TV menu. This allows the installers to do all the TV setup settings.
-
Page 30: Control Settings
Welcome message The Welcome message function allows the TV to show a customized greeting to the hotel guest whenever the TV is switched on. This helps to personalize the hotel experience for guests. The Welcome message can consist of 5 lines of text, with each line containing a maximum of 25 alphanumeric characters. -
Page 31: Speaker Settings
• Selects [EasyLink] > [On] first before enabling [HDMI-CEC in] in Professional mode. • Refer to page 37 “Use Philips EasyLink” for more details about HDMI-CEC function. • [Off]: Disables HDMI-CEC feature in Professional mode. • [On]: Enables HDMI-CEC feature in Professional mode. - Page 32 [Multi RC] Note • A special remote control is needed. Please contact your local Philips sales person for more information. Remote control supports up to four televisions operating in one room without interference from each other’s remote controls. Each TV and the Guest remote control can be set to match each others.
- Page 33 SmartClone [USB to TV] Loads the TV configuration data (including the video, audio, channel Table, and Professional mode settings) from a USB device to the TV set. [TV to USB] Loads the TV configuration data (including the video, audio, channel Table, and Professional mode settings) from the TV set to a USB device.
-
Page 34: Connect Devices
8 Connect devices This section describes how to connect devices with different connectors. Note • You can use different types of connectors to connect a device to your TV. Back connectors IR LINK a HDMI 1 Digital audio and video input from high- definition digital devices such as Blu-ray players. - Page 35 e AV-IN Audio or composite video input from analog devices connected to VIDEO or VCRs. AV-IN f AV-OUT Audio L/R: Analog audio output to home theaters or other audio systems. AV-OUT VIDEO: Analog video output to external devices such as another TV set. AV-OUT g BATHROOM SPEAKER 8 Audio output to a bathroom speaker...
-
Page 36: Side Connectors
i IR LINK Connector for an IR Link compliant device. (e.g. set-up box). It allows the IR command from a Remote Control to be passed on by the TV to the external device, which then sends an action command back to the TV. IR LINK IR LINK IR LINK... - Page 37 c AUDIO L/R Audio input from analog devices connected to VIDEO. d VIDEO Composite video input from analog devices such as VCRs. e HDMI Digital audio and video input from high- definition digital devices such as Blu-ray players. f VOL SPKR SELECT Selects between rotary and tact to operate the volume controller connected with “EXT SPKR VOL CRTL”.
-
Page 38: Connect A Computer
h EXT SPKR VOL CRTL Connector for volume controller via a stereo jack. To adjust the volume of bathroom speaker connected with “2W EXT SPKR OUT”. EXT. SPKR. VOL. CTRL. EXT. SPKR. VOL. CTRL. Rotary-A → volume - Tact-A → volume + Rotary-B →... -
Page 39: Use Philips Easylink
HDMI CEC devices. Enable or disable EasyLink Note • Do not enable Philips EasyLink if you do not intend to use it. Press MENU > [PBS Settings] > [Consumer Setup] > [Yes]. » The consumer menu appears. -
Page 40: Use A Kensington Lock
Use System audio control (One- touch audio) When you connect your TV to HDMI CEC compliant amplifier (such as, a Home theater system or an AV receiver), your TV can switch automatically to play audio from the connected amplifier. To use one-touch audio, you must map the audio input from the connected amplifier to your TV. -
Page 41: Product Information
9 Product information Product information is subject to change without notice. For detailed product information, go to www.philips.com/support. Supported display resolutions Computer formats • Resolution - refresh rate: • 640 x 480 - 60Hz • 800 x 600 - 60Hz •... -
Page 42: Supported Tv Mounts
Supported TV mounts To mount the TV, purchase a Philips TV mount. To prevent damage to cables and connectors, be sure to leave a clearance of at least 2.2 inches or 5.5cm from the back of the TV. Warning •... -
Page 43: Troubleshooting
Disconnect the power cable from the power outlet. Wait until the TV cools down before reconnecting the power cable. If the blinking reoccurs, contact Philips Consumer Care. You forgot the code to unlock the TV lock feature • Enter ‘8888’. -
Page 44: Sound Issues
Contact us If you cannot resolve your problem, refer to the FAQs for this TV at www.philips.com/support. If the problem remains unresolved, contact Philips Consumer Care in your country as listed in this user manual. Warning • Do not attempt to repair the TV yourself. This may cause severe injury, irreparable damage to your TV or void your warranty. - Page 45 11 Index Analogue ANTENNA Batteries Blank Channel Blue mute Channels Channel grid Favourite channels Fine-tune Install Automatic Manual Lock or unlock PayTV Rearrange Rename Skip channels Troubleshooting Computer Connect Display resolutions Troubleshooting Consumer Setup Default setting Display resolutions Dispose EasyLink Disable Enable one-touch play...
- Page 46 one-touch play one-touch standby On timer OSD display Picture Picture formats picture settings Troubleshooting PIN code Power consumption Preferences Product specification Professional mode Options PBS Mode Store Rearrange channels Reception Remote control Consumer remote control Multi RC Product information Professional Setup Remote control Rename channels Resolution Safety...
- Page 48 Z4 0G 320181305A Z41G320181305A © 2010 Koninklijke Philips Electronics N.V. All rights reserved. Document order number: Z41G320181305A...