Omron V460-H Series Connection Manual page 24

2
Confirm that the RUN mode is
shown in the Controller Status
Pane of the Sysmac Studio.
If PROGRAM mode is shown,
select Mode – RUN Mode from
the Controller Menu.
A confirmation dialog box
appears. Click Yes.
3
Check that the controller is in a
Monitor state by the Monitor
and Stop Monitoring Buttons
in the Sysmac Studio toolbar.
The controller is in a Monitor
state if the Monitor Button is
selected (not selectable) and
the Stop Monitoring Button is
selectable, as shown in the
figure on the right.
* If the controller is in a Stop
Monitoring state, select
Monitor from the Controller
Menu in the Sysmac Studio.
4
Select Watch Tab Page from
the View Menu.
7. Connection Procedure
Monitor
Stop Monitoring
21