Omron V460-H Series Connection Manual page 19

7.3.2. Checking Parameters and Executing Builds
Check the setting parameters. Then, perform program checks and builds on project data.
1
Double-click Built-in
EtherNet/IP Port Settings
under Configurations and
Setup – Controller Setup in the
Multiview Explorer.
2
The Built-in EtherNet/IP Port
Settings Tab Page is displayed
in the Edit Pane.
Select TCP/IP, select the Fixed
setting Option in IP Address,
and check that the settings are
as follows.
IP Address: 192.168.188.1
Subnet mask: 255.255.0.0
Default gateway: _._._._
Check that Keep Alive is set as
follows.
Keep Alive: Do not use
Linger option: Do not specify
3 Double-click Task Settings
under Configurations and
Setup in the Multiview Explorer.
4
The Task Settings Tab Page is
displayed in the Edit Pane.
Select Program Assignment
Settings and confirm that
Primary Task is set to
Program0.
7. Connection Procedure
16