Rm-363 Transmitter; General Instructions For Gsm 850 Tx Troubleshooting - Nokia RM-362 Service Manual

RM-362; RM-363
RF Troubleshooting Instructions

RM-363 transmitter

General instructions for GSM 850 TX troubleshooting

Steps
1. Apply a RF-cable to the RF-connector to allow the transmitted signal act as normal. RF-cable should be
connected to an attenuator at least 10dB before connected to the measurement equipment, otherwise
the PA may be damaged.
Phoenix and establish a connection to the phone with the data cable e.g. FBUS.
2. Start
3. Select File and Scan product.
4. Wait a while for the PC to read the information from the phone.
5. Select Testing and RF Controls.
6. Set the parameters as follows:
i Band: GSM 850
ii Active Unit: TX
iii TX Power Level: 5
iv TX Data Type: Random
Results
The setup should now look like this:
Issue 1
Figure 64 RX I/Q signals
COMPANY CONFIDENTIAL
Copyright © 2008 Nokia. All rights reserved.
Page 4 –35