Vacuum Setup - Ryobi RBV3600 Instructions Manual

OPERATION

VACUUM SETUP

1. Remove the battery pack.
Press the latch to unlock and then pull
the battery pack out of the housing.
2. Push the lower vacuum tube into the
upper vacuum tube until you hear and
audible click and the tube locks into
place.
3. Turn the locking screw counterclockwise
to unlock the fan cover. Rotate the fan
cover upward to open the fan housing.
4. Install the vacuum tube assembly.
Push the vacuum tube assembly into
the fan housing until it clicks into place.
Slide the lock lever to the lock position
to secure the vacuum tubes. Rotate the
fan cover downward until it rests on the
upper vacuum tube. Hook the lock clip
to the fan cover and press the lock clip
downward to secure the cover.
NOTE: Ensure that the vacuum tube is
inserted correctly, and that the lock clip
is secure and tight.
WARNING: Never operate the
vacuum with only the upper vacuum
tube fitted. Failure to follow this warning
increases the risk of personal injury.
1
1
2
3
2
1
4
2
3
4
1
2
17