Blower Setup - Ryobi RBV3600 Instructions Manual

OPERATION

BLOWER SETUP

1. Remove the battery pack.
Press the latch to unlock and then pull
the battery pack out of the housing.
2. Attach the high speed nozzle and guide
wheels to the lower blower tube.
Push the high speed nozzle into the
lower blower tube until it locks into place.
Slide the guide wheels onto the lower
blower tube. Use the tab on the rear side
to slide the guide wheel up or down and
adjust its position.
3. Install the lower blower tube assembly,
and upper blower tube to the housing.
Push the lower blower tube assembly
into the upper blower tube until you hear
and audible click and the tube locks into
place.
Push the blower tube assembly into the
housing until it locks into place.
4. Close the fan cover.
Rotate the fan cover downward to close
the fan housing. Rotate the locking
screw clockwise to secure the cover.
NOTE: Ensure to fully tighten the locking
screw to engage the micro switch. If the
screw is not tight, the unit will not work.
1
1
2
1
3
1
4
1
2
2
2
2
15