Introduction; Description Of User Controls And Features - RTS KP95 Operating Instructions Manual

1

INTRODUCTION

This manual describes the operating procedures for the KP95-0 keypanel when used in an ADAM™, ADAM CS
or Zeus™ DSP Intercom System. The KP95-0 must be programmed from a PC with the ADAMedit or ZEUSedit
intercom configuration software. If you need to change the keypanel setup or access other information about the
keypanel setup, you will need to consult with your system administrator.
1
2
Talk
Off
(Talk)
BY
Matrix Intercom System
1. Designation Strip Holder
2. Talk Keys
3. Gooseneck Microphone
2

DESCRIPTION OF USER CONTROLS AND FEATURES

(See Figure 1 for numbered call-outs)
1. Designation Strip Holder: A strip can be inserted here to identify the talk key assignments. Designation strips
show the alphanumeric names for the destinations (intercom ports, party lines, etc.) that have been assigned to
the talk keys. The ADAMedit or ZEUSedit intercom configuration software is used to assign these names and
print the designation strips. See "Alpha Assignments" and "Print" in the application help.
2. Talk Keys: These are used to talk to the keypanels, party lines, etc. that are indicated on the designation strip.
3. Gooseneck Microphone: Pressing any talk key activates the gooseneck microphone.
4. Incoming Messages Key: When a call is received, pressing the incoming messages key will allow you to
respond to the caller.
5. Intercom Volume: The outer volume control knob adjusts headphone and speaker volume for intercom
communications.
4 KP95-0 Keypanel Operation Manual, Ver. 8.2
3
Talk
Figure 1: Keypanel Reference View.
4
Clear
Off
Call
Answer
Incoming Messages
Programing
4. Incoming Messages Key
5. Intercom Volume
5